Electrolux EHD 6005 P User Manual
Page 21
21
If you are unable to remedy the problem by following the above sug-
gestions, please contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by qualified
service engineers. Considerable danger to the user may result from improp-
er repairs.
3
If the appliance has been operated incorrectly, the visit from the service
technician or dealer may not take place free of charge, even during the war-
ranty period.
Display is switching be-
tween two heat settings
Power management is
reducing the power of
this cooking zone
See the section
“Switching the power
function on and off”
is lit
Unsuitable cookware
Use suitable cookware
No cookware on the
cooking zone
Put cookware on zone
Diameter of the base of
the cookware is too
small for the cooking
zone
Move to smaller cook-
ing zone
Use suitable cookware
is lit
Overheating protection
for the cooking zone
has been triggered
Switch off the cooking
zone. Switch the cook-
ing zone on again
Safety cut-out has
been triggered
Switch off the cooking
zone. Switch the cook-
ing zone on again
and number are dis-
played
Electronics fault
Disconnect the appli-
ance from the electrical
supply for a few min-
utes (Take the fuse out
of the house’s wiring
system)
If after switching on
again,
is displayed
again, call the customer
service department
Problem
Possible cause
Remedy