Sony SRX-T110 4K SXRD 11,000-Lumen Projector (No Lens or Lamps) - Manual (Page 19)

Char
ging
a Ba
tter
y P
ac
k
Charging a Battery Pack 19
Charging a Battery Pack
1
Set the Mode select switch to CHARGE.
2
Connect the AC input connector on the BC-U1A and the AC
power source using the AC power cord.
3
Attach the battery pack.
Place the battery pack with the triangle mark facing the charge
connectors and slide it in the direction indicated by the arrow.
Be sure to push the battery pack to engage the charge
connectors until it clicks.
Charging begins, and the CHARGE indicator shows the
charging status.
Flashing in orange: Charged between 0 to 80%
Flashing in green: Charged over 80%
Lit in green: Fully charged
Flashing in orange, green, and off repeatedly: Charging
standby state
This unit has a charging control function controlled by the
temperature. If the internal temperature of the battery is 0 °C
(32 °F) and lower or 60 °C (140 °F) and higher, the unit is in
standby state and charging does not take place. When the
temperature is above 0 °C (32 °F) or below 60 °C (140 °F),
charging takes place.
The charging current is automatically blocked if a battery pack other
than a lithium-ion battery pack is attached. Be sure to charge a
designated battery pack only.
Detaching a battery pack
Slide the attached battery pack in the opposite direction to that when
attaching then pull it up.
Charging time
The time to charge a completely exhausted battery pack to its full
capacity is shown below.
BP-U35: Approx. 90 minutes
BP-U70: Approx. 150 minutes
BP-U100: Approx. 210 minutes
When an abnormality is detected
When one of the following conditions is detected during charging,
the CHARGE indicator flashes in orange and green alternately:
• After the start of charging, quick charging does not begin.
DC OUT
CHARGE
1 2
-
1
2
-
2
3
Lithium-ion Battery Pack
AC power source
AC power cord
AC input
connector
Mode select switch
CHARGE indicator
Note