Samson Expedition Escape+ 6" 2-Way 50W Portable PA System - Manual (Page 9)

Expedition Escape+ • Portable PA System 9
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Quick Start
XPD Wireless Input
•
Plug the XPD USB receiver into the XPD
Wireless USB jack.
• Turn the MIC Volume knob on the Escape+
completely counterclockwise to 0.
• Place a fresh set of AA (LR6) batteries in
the transmitter battery holder, taking care to
observe the polarity markings, then replace the
cover.
• Turn on the power to the transmitter by pressing
and holding Power switch; the indicator LED will
light amber.
• Raise the MASTER VOL up about half way.
• Speak or sing into the mic at a normal
performance level and raise the MIC Volume
control until the desired level is reached.
Bluetooth®
•
Turn the BLUETOOTH VOLUME control down
counterclockwise to 0.
• With the Escape+ and your Bluetooth device
powered on; press the PAIR button on the rear
panel of the Escape+ to make the speaker
discoverable. The Pairing indicator will slowly
flash blue.
• In the settings of your Bluetooth device, set it to
“discover” available devices.
• From the Bluetooth device list, select the
“Escape+ Plus” device.
• If your device asks for a passkey, enter digits
0000 (four zeros) and press OK. Some devices
may also ask you to accept the connection.
• The Escape+ speaker indicates that pairing is complete when the indicator turns steady
blue. You can now stream audio from your device to the Escape+ speakers.
• With the volume control on your Bluetooth device turned up, play some music, and
slowly raise the Escape+ MASTER VOL control until you have reached the desired level.