Samson Graphite 49 - USB/MIDI Keyboard Controller - Manual (Page 17)

17
Graphite 49 · USB/MIDI Keyboard Controller
EN
GL
ISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Setup Mode
Setup mode enables you to make adjustments to how the Graphite 49 will operate. Pressing
the SETUP button will enter Setup Mode, the keyboard will stop transmitting MIDI data, and
the first 17 keys will function as numerical pads.
Controllers
To adjust a controller, press a button, move a
slider or encoder, or press the pedal, and its
name and parameter values will appear on the
display.
Press the PAGE ◀ / ▶ buttons to cycle through
the available parameters. The parameter name
will be displayed and the value will flash. Use
the DATA +/– buttons or numerical keys to set
the appropriate value.
Note: When the value Ch is set to “-“, the
controller follows the keyboard channel in Zone
1. You can use the DATA button to select “-“, or
press the 0 key on the keyboard to select “-“.
Press the ENTER button or the ENTER key on
the keyboard to confirm a selection. You can
confirm the selection after each parameter,
or after you finish editing all parameters for a
controller. The new values will be saved and updated on the display.
Note: The slider and encoder settings are saved into the current activated bank. Press the
BANK ◀ / ▶ to change the bank where the settings will be saved.
If you select another controller, or press the SETUP or MAIN buttons before saving your
changes, your changes will be lost. Simultaneously pressing the DATA + and DATA – buttons
will restore the controller to its original setting.
The setting of sliders, encoders and transport buttons cannot be changed in the Remote
Control Preset. The components assigned to the function buttons vary according to the
software title you are using.
A
B
A
B