Xiaomi Mi Robot Vacuum-Mop - Manual (Page 9)

Routine Maintenance
Cleaning the Washable Filter
Note: Biweekly cleaning is recommended.
1. Open the dust compartment cover at the positions marked with
arrows.
Note: Only clean water should be used to clean the filter. Do not use detergent.
Do not attempt to clean the filter with a brush or finger.
2. Add clean water to the dust compartment, and close the dust
compartment cover, then shake the compartment back and forth,
finally pour out the water. Repeat these steps until the filter is clean.
Side Brush
Note: It is recommended to clean the side brush monthly and replace every 3 to 6 months.
1. Flip the vacuum-mop over, then gently pull out the side brush as
shown in the diagram below to clean it.
2. Reinstall the side brush.
Mop Pad
Note: The mop pad should be cleaned after each use.
1. Pull the mop pad off of the mopping module to remove it.
Wheel
Axle
Holder
Omnidirectional Wheel
Note: The wheel can be cleaned with water and reinstalled after drying.
1. Flip the vacuum-mop over and pull out the omnidirectional wheel.
2. Remove hair, dirt, and other debris from the wheel and axle.
3. Reinsert the wheel and press it firmly back into place.
Note: Filter must be fully dry before use (allow at least 24 hours).
3. Remove the filter as shown in the diagram, forcefully shake it to
remove excess water, then place it aside to dry before reinstalling it.
Note: Remove the pad from the mopping module before cleaning it, and make sure dirty water
does not flow back into the water outlet to avoid clogging. Do not press too hard on the mop pad,
as this can hinder its performance. Pad should be cleaned before each use. It is recommended to
change the mop pad every 3 to 6 months.
2. Clean and dry the mop pad.
13 14