MIDEA MPF08CR71 - Manual (Page 11)


Page 10

Oper
ating
Ins
tructions
FOLLOW ME/TEMP SENSING
Feature (optional)
Other Features
NOTE
This feature can be activated fro m the re m ote control ONLY. The re m ote control
serves as a re m ote ther m ostat allowing for the precise te m perature control at its
location.
NOTE
On so m e m odels the louver can be adjusted m anually only):
• When the Power is ON, the louver opens fully.
• Press the SWING button on the panel or re m ote controller to initiate the Auto
swing feature. The louver willl swing up and down auto m atically.
• Please do not adjust the louver m anually.
To activate the Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes interval until press the Follow Me/Temp Sensing button again. If the unit
does not receive the Follow Me/Temp Sensing signal during any 7 minutes interval, the
unit will beep to indicate the Follow Me/Temp Sensing mode has ended.
AUTO-RESTART
If the unit breaks off unexpectedly due to the power cut, it will restart with the previous
function setting automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted operation in the first 3 minutes. This is
to protect the unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the air flow direction automatically.
Water drainage
• During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector (5/8” universal female mender) with 3/4”
hose (locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement floor.
Remove
the upper
drain plug
¥
Continuous
drain hose