beautypg.com

Instructions for use, Downloading app, Reset wifi – Roborock Q7+ FCC User Manual

Page 8: Add device, On/off, Starting cleaning, Pause, Sleep

background image

08

Option 1: Search for “Roborock” in the App

Store or Google Play or scan the QR code to

download and install the app.

Downloading App

Option 2: Search for “Mi Home” in the App

Store or Google Play or scan the QR code to

download and install the app.

Reset WiFi

1.

Open the upper cover and find the WiFi

indicator.

If you cannot connect to the robot due to your router

configuration, a forgotten password, or any other reason,

reset the WiFi and add your robot as a new device.

Note:

Open the Roborock App, tap the “Search for

device” button, or open Mi Home app, tap “+”

in the top right corner and add the device as

instructed in the app.

Notes:

The actual process may vary due to ongoing app updates.

Follow the instructions provided in the app.

Only 2.4 GHz WiFi is supported.

If the robot waits more than 1 hour for a connection, WiFi

will be automatically disabled. If you want to reconnect,

reset the WiFi before proceeding.

Add device

2.

Press and hold the and buttons

until you hear the “Resetting WiFi” voice

alert. The reset is complete when the WiFi

indicator flashes slowly. The robot will then

wait for a connection.

Instructions for Use

Press and hold the button to turn on the

robot. The power indicator will turn on and

the robot will enter standby mode. Press

and hold the button to turn off the robot

and complete the cleaning cycle.

On/Off

Note:

The robot cannot be turned off when it is being charged.

Press the button to start cleaning. The

robot will plan its cleaning route according

to its scan of the room. It splits a room

into zones, first draws out zone edges, and

then fills the zone in a zigzag pattern. In

so doing, the robot cleans all zones one by

one, efficiently cleaning the house.

Starting Cleaning

Zone 1 – Cleaned

Zone 4 – Next Zone

Zone 2 – Cleaned

Zone 3 – In Progress

Note:

Placing a paused robot on the dock manually will end

the current cleanup.

Press any button to stop the robot during

operation. Press the button to resume

cleanup. Press the button to send the robot

back to the dock and end the current cleanup.

Pause

Notes:

Cleanup cannot start if the battery level is too low. Allow the

robot to charge before starting cleanup.

If cleanup is completed in less than 10 minutes, the area will

be cleaned twice.

If the battery runs low during the cleaning cycle, the robot

will automatically return to the dock. After charging, the

robot will resume where it left off.

To allow the robot to automatically vacuum and return to

the dock, start the robot from the dock. Do not move the

dock during cleaning.

If the robot is paused for over 10 minutes, it

will go to sleep, and the power indicator will

flash every few seconds. Press any button to

wake it up.

Sleep