Philips AVENT SCF875/01 - Manual (Page 16)

14 ENGLISH
Note
• The jar has grooves that help smoothly guide the locking pins and lock the lid
in place. Make sure that the lid tab slides into the handle of the jar (Fig. m).
6
Flip the jar over with the jar lid on the bottom (Fig. z).
7
Align the connector on the jar lid to the locking area on the water tank, and
then place the jar on the main unit with the jar lid on the bottom (Fig. {).
Press the jar downwards to lock it firmly on the main unit, and make sure the
handle is on the right-hand side.
Note
• Make sure the water tank lid is correctly locked in place before placing the jar
on the main unit.
8
If the control knob is not in the off position ( OFF), turn it to the off position
first.
9
Plug in the appliance.
10
Turn the control knob to select the reheat time that matches with the storage
pot placed in the jar (Fig. p).
» Choose 15 minutes ( ) if using the 120 ml storage pot; choose 25
minutes ( ) if using the 240 ml storage pot (purchased separately).
» The steaming light will turn white to indicate that the appliance is
reheating.
11
When the reheating cycle is finished, the appliance will beep and the
steaming light will turn off.
12
Turn the control knob back to the off position ( OFF) (Fig. q). Wait 2 minutes,
or until there is no more steam coming from the top of the appliance before
removing the jar.
13
Open the jar lid, and use the hook on the spatula to take the storage pot out
(Fig. |).
14
There may still be some water remaining in the water tank after a reheating
cycle. This is normal. Wait until the appliance cools down to room
temperature, then empty the water tank of all residual water. To empty or
clean the water tank, refer to the chapter “Cleaning and descaling”.
Defrosting
If you have used the special storage pots to freeze blended food, you can use
the appliance to gently defrost the frozen food.
Note
• Always put previously blended food in the storage pot to defrost.
• Make sure that the sealing ring is assembled around the jar lid before
defrosting, and that the flat side of the sealing ring is facing out.