Philips AVENT SCF875/01 - Manual (Page 24)

26
ENGLISH
Problem Possible cause Solution
Temperature of
the defrosted
food is still low. There is too much
food in the storage
pot. Make sure that the amount of food in
the storage pot does not exceed the
maximum scale marked on the side of
the pot.
Food in the storage
pot is too viscous. Let the appliance cool down for 10
minutes and defrost again.
The storage pot
leaks during
reheating/
defrosting. The storage pot lid is
not closed correctly. Before putting the storage pot in the jar
to reheat/defrost, make sure that the lid
is closed correctly.
Water in the
water tank has
an unusual color
when you pour it
out of the water
tank or when it
enters the jar
during steaming,
or the water in the
water tank has an
unpleasant smell. Food particles have
entered the water
tank during use. Clean the water tank according to the
instructions in the chapter “Cleaning and
descaling”. Use the appliance strictly
according to the instructions. Make sure
you do not overfill the water tank with
water (max. 250 ml) and that you do not
overfill the jar with food (do not fill the
jar past the top edge of the gray blade
unit). Do not steam the same ingredients
for more than 30 minutes or add liquid
to the jar to steam. After you have put
liquids in the jar, never put the jar in the
steaming position with the jar lid on the
bottom.
There are white
spots on the water
tank, water tank
lid, jar, jar lid and
sieve. There is limescale
buildup on these
parts. This is normal. Remove the limescale
periodically. Clean the water tank lid,
jar, jar lid and sieve with a moist cloth.
Descale the water tank. Refer to the
section “Descaling” in the chapter
“Cleaning and descaling”.
The surfaces that
come into contact
with food are
discolored. Food colorings may
discolor the parts that
come into contact
with food. This is normal. All parts are still safe to
use and will do no harm to the cooked
food.
The appliance
sounds 5 times
and the steaming
light flashes
during steaming,
reheating or
defrosting. The jar is out of
position or removed
from the main unit
during processing. Turn the control knob to the off position
(OFF), check the water amount in the
water tank, place the jar on the main unit
correctly, and reselect the processing
time to start again.