Electro-Voice 3-Inch High Frequency Neodymium Transducer ND6-16 - Manual (Page 2)

General Description (Cont’):
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 2/2002
Part Number 38110-083 Rev. A
Dimension Drawings:
Frequency Response (On a Tube):
Frequency Response (On an HP94 Horn):
ND6-8 Part Number: 301051-102
ND6-16 Part Number: 301052-102
Top View
Side View
Bottom View
Pure aluminum rectangular voice coil wire is used to obtain
the highest sensitivity. Proprietary bonding and winding
technologies assure unsurpassed reliability.
Electro-Voice’s commitment to precision compression driver
manufacturing and modern design techniques assure the
ND6 user the highest level of audio and engineering
excellence.
Dimension Drawings (Cont’):
Accessories:
• ADH-6 Adapter (For 2” Exit) 591183-102
(must be purchased separately)
Side View
(Shown with
Optional ADH-6
Adapter)
Note: Frequency response and impedance of the ND6-16 driver attatched to a
38mm (1.5”) diameter plane wave tube, using one watt input (4 Vrms).
Note: Frequency response and impedance of the ND6-16 driver attached to an
HP94 Horn, measured on axis in the far field using one watt input (4 Vrms). SPL
calculated to 1 meter equivalent by inverse square law.