Emerson CF2500HTW01 - Manual (Page 3)

1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following:
a. Fan motor and housing assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One switch housing cover assembly
h. One uplight lead assembly
i. One loose parts bag containing:
1. One setscrew
2. One 5/32" hex wrench
3. One 3/16” hex wrench
4. Eleven 10-32 x 5/8" oval head screws
5. Two 1” threaded studs
6. Two 1-1/4” threaded studs
7. Four knurled knobs
8. Three wire connectors
9. Four 8-32 x 3/8" flat head screws
10. One pull chain pendant and coupling
11. One hairpin clip
12. One clevis pin
13. Four lockwashers
14. Sixteen 10-24 x 3/8" pan head screws
15. Sixteen flat washers
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
Three wire connectors (supplied.) One wire stripper
MATERIALS
Wiring, outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of size shown at right:
3
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
NOTE: Place the parts from the loose parts bags
in small containers to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
NOTE: Fan blades are ordered separately and are
packaged in separate carton.
MOTOR
COVER
HANGER
BRACKET
FAN MOTOR AND
HOUSING ASSEMBLY
UPLIGHT LEAD
ASSEMBLY
LOOSE
PARTS BAG
HANGER BALL/
DOWNROD
ASSEMBLY
SWITCH HOUSING
COVER ASSEMBLY
BLADE
FLANGES
FOAM PACKING
CARTON
CEILING
COVER
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan. If you feel you do not
have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
WARNING !
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson. Substitution of parts or accessories not
designated for use with this product by Emerson
could result in personal injury or property damage.
WARNING !
WARNING !