Electrolux WA SL1 E100 - Manual (Page 32)

2. Remove the conditioner insert from the middle compartment.
3. Clean all parts with water.
4. Put the conditioner insert in as far as it
will go, so that it is firmly in place.
5. Clean all parts of the washing ma-
chine, especially the nozzles in the top
of the washing-in chamber, with a
brush.
6. Insert the detergent dispenser drawer in the guide rails and push it in.
Washing drum
Rust deposits in the drum may occur due to rusting foreign bodies in the
washing or tap water containing iron.
Important! Do not clean the drum with acidic descaling agents, scouring agents
containing chlorine or iron or steel wool.
1. Remove any rust deposits on the drum with a cleaning agent for stainless
steel.
2. Run a washing cycle without any washing to clean off any cleaning agent
residues. Programme: COTTONS/LINEN 90° or 95°C, press the button 6 , add
approx. 1/4 measuring cup of detergent.
Door seal
Check from time to time the door seal and eliminate
eventual possible objects that could be trapped in the
fold.
Drain pump
The pump should be inspected regularly and particularly if
• the machine does not empty and/or spin
• the machine makes an unusual noise during draining due to objects such as
safety pins, coins etc. blocking the pump.
Proceed as follows:
1. Disconnect the appliance.
2. If necessary wait until the water has cooled down.
3. Open the pump door.
4. Place a container close to the pump to collect any spillage.
32 Care and cleaning
132966060_GB.qxd 29/11/2007 15:17 Pagina 32