Electrolux WA SL1 E100 - Manual (Page 30)

Pour liquid detergent into the dispenser drawer compartment marked just
before starting the programme.
Any fabric softener or starching additives must be poured into the compartment
marked
before starting the wash programme.
Follow the product manufacturers’ recommendations on quantities to use and do
not exceed the «MAX» mark in the detergent dispenser drawer.
Quantity of detergent to be used
The type and quantity of detergent will depend on the type of fabric, load size,
degree of soiling and hardness of the water used.
Follow the product manufacturers’ instructions on quantities to use.
Use less detergent if:
• you are washing a small load,
• the laundry is lightly soiled,
• large amounts of foam form during washing. For the stain treatment before
the washing cycl, follow the product manufacturers’ instructions on
detergent quantities. If you use any specific product to remove the stains, you
must start the cycle of washing immediately .
Degrees of water hardness
Water hardness is classified in so-called “degrees” of hardness. Information on
hardness of the water in your area can be obtained from the relevant water
supply company, or from your local authority.
Note: A water softener must be added when water has a medium-high degree
of hardness (from degree of hardness II). Follow the manufacturer’s instructions.
The quantity of detergent can then always be adjusted to degree of hardness I (=
soft).
30 Preparing the wash cycle
LLeevveell
1
Characteristic
soft
D Deeg grreeeess o off w waatteerr h haarrd dn neessss
G Geerrm maan n
°°d dH H
FFrreen ncch h
°°TT..H H..
0-7 0-15
2 medium 8-14 16-25
3 hard 15-21 26-37
4 very hard > 21 > 37
132966060_GB.qxd 29/11/2007 15:17 Pagina 30