Extron electronic TP R BNC A - Manual (Page 8)

TP Receivers • Installation and Operation TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-3
Installation Overview
To install and set up a TP receiver and the associated TP
transmitter(s) for operation, perform the following steps:
1 Disconnect power from all of the equipment, including the
video source(s) (such as computers or DVD players), the
transmitter, the receiver, and the output display(s).
2 For component, S-video, or composite video, ensure that
the internal jumpers (TP R BNC A and TP R BNC AV) or
external DIP switch (TP R 15HD A) are in the correct
position. See Video jumpers or Video DIP switch in this
chapter.
3 TP R BNC AV and TP R AV only — If desired, configure
the audio jumpers to make the receiver compatible with
unmodified TP transmitters. See Audio jumpers in this
chapter.
The TP R BNC AV and TP R AV are redesigned
(modified) receivers. The audio jumpers configure the
audio portion of the composite video TP link to work
with either similarly redesigned TP T 15HD AV and
TP T AV transmitters or with older, unmodified
transmitters. Redesigned receivers and transmitters
have an identifying label.
4 Mount the receiver in a rack (all except TP R AV) (the
TP R 15HD A can be mounted in a standard rack or in a
VersaTools rack), under a desk or podium, in a desk or
table (all except TP R 15HD A), or on a projector bracket.
See Mounting the receiver in this chapter.
5 Connect the cable(s) between the TP transmitter(s) and the
receiver. See Transmitted signal cabling in this chapter and
refer to the TP Transmitters Family User’s Manual, part
#68-546-01.
6 Connect the output cables. See Output cabling in this
chapter.
7 Configure the TP transmitter(s). Refer to the TP
Transmitters Family User’s Manual, part #68-546-01.
8 Connect power cords to the TP receiver, the TP
transmitter, and turn on the video source(s) and the
output display(s).
2-2
All TP transmitters include a 15V external power
supply. The transmitters also receive power from the
associated Extron TP receiver(s) (with the exception of
the TP R 15HD A) via the TP cable. Extron
recommends using the local power supply; however, the
power supply may not be necessary in some applications.
Use the following guidelines:
• The TP T 15HD A, TP T 15HD AV, and
TP T BNC may not require a local power supply for
cable lengths of 300 feet or less.
• The TP T AV may not require a local power supply
for cable lengths of 800 feet or less.
• The TP T BNC DA4 and any transmitter
connected to a TP R 15HD A always require the
local power supply.
If problems are encountered, use the local power supply.
9 Adjust the picture controls on the transmitter(s) and the
receiver. See Controls and Indicators in this chapter and
refer to the TP Transmitters Family User’s Manual, part
#68-546-01.
Video jumpers
The TP R BNC A and TP R BNC AV receivers can be configured
to receive component video, S-video, or composite video.
The receivers are factory configured for RGB video. To
receive any other type of video, reconfigure the jumpers.
Installation and Operation