OPHIT DMS-H1616 - Manual (Page 9)

General Specification
9
This equipment has been tested and found to comply with the limits of a Class A
digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against interference.
This monitor can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, it may interfere with other radio communications
equipment. There is no guarantee that interference will not occur in a particular
installation.
If this equipment is found to cause harmful interference to radio or television
reception, the user is encouraged to try to correct the interference by carrying out
one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the color monitor and the subject of
interference.
3. Plug the monitor into a outlet on a different electrical circuit than \that to which
the subject of interference is connected.
4.Consult the dealer or an experienced radio/TV technician for help.
NOTICES TO USER :
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC WARNING :
This equipement geneates or uses radio frequency energy. Changes or
modifications to this equipement may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could
lose authority to operate this equipment if an unauthorized change or modification
is made.
FCC Information
Emission test Compliance Electromagnetic environment-guidance
RF emissions
FCC Part15 Subpart B
Class A The model DMS-H1616 uses RF energy only for
its internal function Therefore. Its RF emissions are
very low and are not likely to cause any interference
in nearby electronic equipment