Erasing a single messages, Operation(continued) specifications, Operation(continued) 1 2 1 2 – Mpman ICR110 User Manual

Page 4

SCAN PLAYBACK

This unit can play back the first five seconds of each recorded message,

which is useful in locating a particular recording.

ERASING A SINGLE MESSAGES

While in the standby mode, select the

desired file folder using the FILE/TIME

button

, and the desired message to delete

using the REV

or FWD button

;

the message number and the message length

will appear in the display.

ERASING ALL MESSAGES IN THE 4 FILE FOLDERS

IMPORTANT NOTES:

.Once message(s)are deleted, they cannot be recovered.

.When the memory is full, Full will appear in the display.

OPERATION(CONTINUED)

SPECIFICATIONS

Recording System……………...................................................Built-in Flash Memory

Recording time…………………………………………………..3369 minutes in LP mode

Speaker………………………………………………………………………….0.2W(8 Ohm)

Output Power…………………………………………………………………………..80mW

Power Source…………………………..3V, “AAA” size×2 batteries(Not Included)

Battery life..........................................Approx 10 hours at recording mode

5 hours at play mode at volume level Max.

Dimensions........................................................................106(H)×36(W)×17(D)mm

Weight....................................................................................50g(without batteries)

Specifications are subject to change without notice.

While in the standby mode,

select the file folder(A,B,C,D) using the

FILE/TIME button

,Press and hold the

PLAY/STOP button

for 2 seconds; SCAN

will appear in the display. The unit will

appear in the display. The unit will

automatically scan and play the first five

seconds of each message in the selected

file folder, starting at message one.

The unit will automatically stop after all
Messages have been played. To
playback the message during
scanning, press the change to
playback mode. To stop scan
playback,
Press the PLAY/STOP button twice.

While in the standby mode, press and hold

the ERASE/REPEAT button

first, then

press and hold the REC/STOP button

for

two seconds; ALL and ERASE will blink in

the display.

To erase all messages, press the

ERASE/REPEAT button again within 5

seconds. If the ERASE button is not pressed

again within the first 5 seconds, the messages

will not erase.

OPERATION(CONTINUED)

Press the ERASE/REPEAT button; ERASE will

appear in the display and the first 5 seconds of

the message will play. To erase, press the

ERASE/REPEAT button within the 5 seconds it

is playing and the rest of the messages will be

renumbered. If you do not want to erase, do

not press the ERASE/REPEAT button while it

is playing.