Electrolux ZKR1516 - Manual (Page 9)

Problem Possible cause Solution
The temperature regulator is not set
correctly. Set a higher temperature.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power (the
maximum power is shown on the light bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Technical data
ZKR1516 ZKR1506 ZKR1526
Dimension
Height 850 mm 850 mm 850 mm
Width 550 mm 550 mm 550 mm
Depth 612 mm 612 mm 612 mm
Rising Time 11 h 11 h 11 h
The technical information are situated in the rating plate
on the internal left side of the appliance and in the en-
ergy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
9