Echo PB-770H - Manual (Page 15)

PB-770 H/T ASSEMBLY
X7531123904 15
© 4/2013 ECHO Inc.
8. Assemble straight pipe (J) onto swivel pipe (C), until you feel
light resistance. Do not force connection. Hold swivel pipe
and turn straight pipe clockwise, engaging positive locking
channels, until connection is firm. Do not force connection.
9. Assemble straight pipe with decal (K) to straight pipe (J) as
in step 8.
Note:
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If
loosening occurs, remove two straight pipes and install
according to instructions 8 & 9.
PB-770 T
Never perform maintenance or assembly procedures with engine running or serious personal injury
may result.
Install Blower Pipes
1. Place guide loop (G) across clamp, and turn until clip fully
engages clamp band.
Note: Clamp with cable guide loop (G) fits elbow end of flexible
pipe (B).
2. Assemble clamps (A) onto both ends of flexible pipe (B).
3. Assemble swivel pipe (C) into flexible pipe (B) and tighten
clamp (A).
Note: Hang handle freely from blower to assure throttle cable is
not twisted before installing handle (E).
4. Loosen knob (H) on handle (E). Align notch in handle with
tabs (F). Install onto swivel pipe (C) past long ridges in pipe.
5. Insert anti-static wire through flexible pipe (B).
C
J
K
G G
A
G
B
A
C
E
H
F
C