Amprobe DM-4 Power-Quality-Recorder - Manual (Page 35)

10. CONNECTING THE INSTRUMENT TO A PC
In order to connect the instrument to a PC you must connect the serial cable
shipped with the instrument to the serial output of the PC.
The DM-IV serial cable has the following inner connections:
The available transmission speeds are the following:
4800, 9600, 19200, 57600(default value)
The value of the transmission speed (Baud Rate) must be selected on the Remote User
Interface (PDA) or the Download Suite in order to have proper communication. The down-
load suite will always look for COM1 first if the setting is set to AUTOMATICALLY.
For download suite instructions please refer to software help file.
In order to transfer the recorded data from the instrument to the PC the following
procedure must be followed:
1) Switch ON the instrument
2) Connect the serial output of the instrument to the serial output of the
PC through the serial cable
34
DM-4 Power Quality Recorder
2
Male connector 9 pins 3
on the instrument side 5
2
3 Female connector 9 pins
5 on the PC side