Amprobe TMA40 Airflow-Anemometer - Manual (Page 7)

6
id: press ediT to enter the user id. Use the keypad to enter the information. 5.
Note: To calculate air volume, first enter the value of the air source area. Three choices are
available: length x width (rectangle); diameter(Circle); and Area.
Range from 0~300cm (Rectangle and Circle and 0~90000sq.cm for area.
Single Measurement: MEAS (See Fig. 3)
press f1 to enter the single measurement mode. •
press f2 to select the type of input •
press eSC to return to previous menu •
Multiple Measurement: MEM (See Fig. 4)
in this mode, you can manually record what you measure in real time and attach a file name
with the recording. There is a total of 99 memory locations in this mode.
press f2 to enter the multiple measurement mode. •
press f2(MeAS) to start a measurement. •
press AboRT(f1) to cancel the measurement . •
press SAVe(f4) to save the recording. •
press f3(ediT) to edit the file name of the recorded value. Use the keys to enter the name. •
press and hold to move from one character to another. Release the key to select the desired
character.
press ClR(f2) to delete a selected character.
•
press and hold ClR(f2) for over 2 seconds to delete the whole memory. •
Automatic Logging: LOG (See Fig. 5)
in this mode, you can automatically record what you have set up before a real time
measurement.
press f3(log) to enter the log mode. •
press SeT(f3) to set up the parameters for the recording. •
press • keys to select a parameter.
press ediT to modify begin date, start time, end date, suspend time, and the rate ( 1 to 200 •
seconds).
expect is 2400 points(total memory) and remain (remaining memory) will be calculated
•
according to your setting.
press nexT
•
press START to begin the logging session •
press View to see the recording data •
press MeAS to see the real time data measurement. •
press eSC to return to previous screen. •
press STop to suspend the logging session. •