Amprobe SOLAR-500 Solar-Analyzer - Manual (Page 23)

17
Setup Menu
1. Press (SETUP) button to enter the Parameter Setting screen.
2. Press or buttons to select the setting items.
(1) Time delay before scan
(2) Current Range of Scan begin
(3) Current Range of Scan end
(4) Area of Solar Cell or Panel
(5) Irradiance
(6) Single Test Point
(7) Alarm of Low Power
3. Press or buttons to select the setting items.
Press or buttons to change the setting values, or press them for
few seconds to promptly change setting values.
4. After setting Parameters, press button to exit SETUP menu.