Amprobe BAT-500 Battery-Impedance-Tester User Manual

Page 18

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.

1. Check the battery. Replace the battery immediately when the symbol “

” appears on the LCD.

2. Review the operating instructions for possible mistakes in operating

procedure.

Except for the replacement of the battery, repair of the meter should
be performed only by a Factory Authorized Service Center or by other
qualified instrument service personnel. The front panel and case can be
cleaned with a mild solution of detergent and water. Apply sparingly
with a soft cloth and allow to dry completely before using. Do not use
aromatic hydrocarbons or chlorinated solvents for cleaning.

Battery Check & Replacement

1. As battery power is not sufficient, the

will be shown on LCD. To

replace with six new 1.5V batteries is required.

2. a). Disconnecting test leads.

b). Turning off the tester.

c). Open the battery cover with screw driver.

d). Replace the batteries. (Please note battery polarity)

e). Cover and secure the battery cover.

Step 1.

Step 2.

Step 3.