Amprobe BAT-500 Battery-Impedance-Tester User Manual
Page 13
6
6. Press u key one time, the high limit impedance of the “two higher
digits” will be flashing. (Use the p & q keys to select the desired value.)
7. Press u key one time, the high limit impedance of the “two lower
digits” will be flashing. (Use the p & q keys to select the desired value.)
8. Press u key one time, the throughold voltage of the “tow higher digits”
will be flashing. (Use the p & q keys to select the desired value.)
9. Press u key one time, the throughold voltage of the “two lower digits”
will be flashing. (Use the p & q keys to select the desired value.)
10. Repeat step 2 to step 9 to set the next comparator number.
11. Press SET key again to exit from comparator setting mode.
Comparator Tables
Impedance
Voltage
Low limit impedance High limit impedance
Voltage Lo
Comparison
Value Hi
WARNING
Beeper
WARNING
Beeper
FAIL
Beeper
Pass
WARNING
Beeper
FAIL
Beeper
Start / Stop Controls the Comparator
1. Press SET key to start comparator function, the COMP indication will
appear on the display, and the comparator will be operating once the
measurements are taken.
2. Press p and q keys to select the desired comparator number. The
selected comparator number remains in memory even the power is
turned off.
3. Press
R
key to set the beeper on, the
indication will appear on the
display, and the beeper will sound when getting the WARNING or FAIL
result. Press
R
key again to set the beeper off.
4. Press SET key again to stop comparator function.
Lo
Middle
Hi