Amprobe 5XP-A 15XP-A 35XP-A - Manual (Page 18)

11 12
HOLD Measurements
The HOLD button causes the meter to capture and
continuously display a measurement reading. To use the
HOLD feature make a measurement, and then,after the
reading has stabilized, momentarily press the HOLD button.
You can remove the test leads and the reading will remain
on the display. Pressing the HOLD button again releases the
display.
PRODUCT MAINTENANCE
Cleaning
To clean the meter, use a soft cloth moistened with water. To
avoid damage to the plastic components do not use benzene,
alcohol, acetone, ether, paint thinner,lacquer thinner, ketone
or other solvents to clean the meter.
Troubleshooting
If the meter appears to operate improperly, check the
following items first.
1. Review the operating instructions to ensure the meter
is being used properly.
2. Inspect and test the continuity of the test leads.
3. Make sure the battery is in good condition. The low
battery symbol  appears when the battery falls
below the level where accuracy is guaranteed.Replace
a low-battery immediately.
4. Check the condition of the fuses if the current ranges
operate incorrectly.
Battery and Fuse Replacement
(See Figure 14)
� Warning
To avoid electrical, shock remove the test leads from both
the meter and the test circuit before accessing the battery or
thefuses.