Amprobe 5XP-A 15XP-A 35XP-A - Manual (Page 15)

7 8
3. Turn off power to the circuit being measured.
4. Discharge the capacitor using a 100 k resistor.
5. Free at least one end of the capacitor from the circuit.
6. Connect the test probes across the capacitor.
7. Read the display.
Measuring Temperature
(35XP-A only) (See Figure 9)
1. Set the function switch to appropriate °C or °F range.
2. Connect the K-type thermocouple to a TEMP adapter
(XR-TA). Match the polarity of the adapter to the
polarity of the thermocouple.
3. Connect the TEMP adapter to the V  and COM
inputs.
Note: The 35XP-A is compatible with all K-type
thermocouples. The K-type bead thermocouple
supplied with the meter is not intended for contact
with liquids or electrical circuits.
4. Expose the thermocouple to the temperature to be
measured.
5. Read the display.
Measuring Frequency
(35XP-A only) (See Figure 10)
1. Set the Function Switch to Hz.
2. Connect the test leads: Red to Hz, Black to COM.
3. Connect the test probes to the signal source.
4. Read the display.
Measuring NCV
(Non-Contact Voltage) (See Figure 11)
1. Range switch may be set to OFF or any function/range.
2. Test leads are not used for the NCV test.