DE DIETRICH DRH914JE - Manual (Page 30)

30
If you cannot find the remedy for a malfunc-
tion in these operating instructions, please
contact your dealer or our customer service
department and consult the Guarantee card.
Selective ordering of replacement parts can
save unnecessary travel and costs.
For this reason always provide the following
appliance information:
Model Name
Model Number (PNC)
Serial Number (S-No.)
This information can be found on the rating
plate inside the cabenit on the left hand wall.
We recommend that you enter this informa-
tion here, so that it is handy if needed.
Technical specifications
The technical data is indicated in the rating
plate on the left side inside the appliance.
Customer service and spare parts
Take utmost care when handling
your appliance so as not to cause
any damages to the cooling unit
with consequent possible fluid
leakages.
During normal operation, the condenser
and compressor at the back of the appli-
ance heat up considerably. Always ensure
that there is adequate ventilation as a fail-
ure to do this will result in component fail-
ure and possible food loss. See installa-
tion instructions.
Important: if the supply cord is damaged,
it must be replaced by a special cord or
assembly available from the manufacturer
or its service agent.
Positioning
Unpack the cabinet and check that it is in
good condition and free of any transport
damage.
The appliance must not be located close
to radiators or gas cookers.
Avoid prolonged exposure of the appli-
ance to direct sunlight.
For safety reasons, minimum ventilation
must be as shown in Fig.
Attention: keep ventilation openings clear
of obstruction.
It is necessary that the niche is provided
with a conduct of venti-lation having the
following dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be found on the
rating plate, which is located inside the cabi-
net on the left hand wall.
The following table shows which ambient tem-
perature is correct for each climate classifica-
tion:
Climate for an ambient
classification temperature of
SN +10 to +32 °C
N +16 to +32 °C
ST +16 to +38 °C
T +16 to +43 °C
Installation