DE DIETRICH DRC927JE - Manual (Page 24)

Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
carded together with the urban refuse
and rubbish. The insulation foam con-
tains flammable gases: the appliance
shall be disposed according to the ap-
plicable regulations to obtain from your
local authorities. Avoid damaging the
cooling unit, especially at the rear near
the heat exchanger. The materials used
on this appliance marked by the symbol
are recyclable.
Control panel
Fridge Control panel
1 2 3 4 5 6 7
1 Pilot light
2 ON/OFF switch
3 Temperature regulator (warmest)
4 Temperature indicator
5 Temperature regulator (coldest)
6 Auto Fresh light
7 Auto Fresh button
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Important! At start-up the displayed
temperature don't correspond with the set
temperature until stabilised (within 24 hours).
Switching off
Press ON/OFF switch until a countdown
from -3 -2 -1 is completed.
The temperature indicator switches off. The
Pilot light switches off.
Temperature regulation
The temperature can be adjusted between
+2°C and +8°C.
By pressing the Temperature regulators, the
current temperature setting flashes on the
Temperature indicator. It is possible to mod-
ify the setting temperature only with flashed
indicator. To set a warmer temperature,
press warmest Temperature regulator. To
set a colder temperature, press coldest Tem-
perature regulator. The Temperature indica-
tor displays the newly selected temperature
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
fridge.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the com-
partment.
Auto Fresh function
The maximum performance is obtained by
setting the Auto Fresh function. It’s recom-
mended when loading large quantities of
food.
You can activate the Auto Fresh function by
pressing the Auto Fresh button.
The Auto Fresh light will light up.
Important! The internal temperature goes
down to +2°C.
After about 6 hours the Auto Fresh function
switches off automatically.
24