DE DIETRICH DVH930 User Manual

Page 22

14 / IF OPERATING ANOMALIES OCCUR

• SUMMARY OF THE FAULTS

• WHEN FIRST PUTTING INTO SERVICE

Problem

Possible

auses

What to do ?

The door falls heavily when
opened (integratable model)

- Door springs not tensioned

enough to compensate for the
weight of the panel.

- Tighten the two tensioning

screws accessible in the bottom
section above the front feet.

The door does not stay horizontal
when open or returns too quickly
(integratable model)

- Door springs tensioned too

much.

- No wooden panel.

- Loosen the two tensioning

screws accessible in the bottom
section above the front feet

- Fit a wooden panel on the

appliance (chipboard panel in
temporary) and adjust the
springs.

The door catches when closing - Appliance not stable

- Door not centred on the tub

- Adjust the feet.
- Re-centre by adjusting the

rear feet.

The upper basket does not stay
in the high position

- Poor manipulation (the basket

is being pulled upwards too
quickly)

- Act more progressively (see

instructions), one side and
then the other.

Small leak around or under the
appliance (move the appliance
to locate the leak better)

- Leak from the tap.

- Leak from the appliance.
(Cf. table fault d07).

- Check that a seal is fitted and

retighten the nut.

- Close the water tap and call a

technician.

Small leak at the door

- Appliance not stable or not level
- Door not centred on the tub.

- Adjust the feet.
- Re-centre by adjusting the rear

feet.

Flashing LED

for models without a display

Flashing LED(s)

d01: water supply fault (tap)

d07: overflow / anti-leak fault

d02: draining fault

d08: sprinkling distribution fault

d03: heating fault

d11: pressure sensor fault

d04: temperature fault

d12: filling fault (water inlet

detection system)

d05: fault – motor under load

d13: overheating fault

d06: fault - motor overload

d14 : bad drain tube connection or
tap flow insufficient or filters dirty.

Tip:

If one of the above faults occurs and you need to call a repair man, remember to tell him

the message displayed (

Flashing LED

) as this information will help him.