DE DIETRICH DVC829WE1/XE1 - Manual (Page 27)

57
13/ IF OPERATING ANOMALIES OCCUR EN
• POOR OPERATION
Problem Possible C auses What to do ?
Constant filling
A lot of waste on the large filter
at the end of the cycle.
- (Cf. table fault d12). Drain hole
situated too low for the
appliance.
- The filters and drain outlets are
blocked with too much
residue.
- Drain wand fallen on the floor.
- Remove and clean the filters
and the bottom of the drain
outlets. Remove large residue
from the plates before putting
them in the machine.
Traces of rust on stainless steel - Quality of the stainless steel
not dishwasher-safe (knives in
particular)
- Use “special dishwasher-safe”
cutlery.
- Check that the stopper on the
salt container is closed correctly.
• POOR DRYING RESULTS
Problem Possible C auses What to do?
A lot of droplets on the glasses. - Lack or insufficient amount of
rinsing product.
- The dose has not been distrib-
uted.
- Positioning of the items.
- Check the indicator light and
fill the tank completely.
- If the tank is not empty after
approximately 60 washings,
call a technician.
- To alleviate the phenomenon,
arrange the items to restrict
water retention as much as
possible. Leave the door ajar
for a few minutes, if possible
Droplets on plastic items, Tefal
coatings, etc. - These insulating items have a
low calorific mass.
- Arrange them preferably in the
upper basket.
Poorer drying on rapid
programmes - On rapid programmes, the drying
temperature and drying period are
reduced to cut down the duration
of the cycle as much as possible.
- Select a rapid programme
carefully or leave the door ajar
for a few minutes.
Condensation on the wall of the
inside door or the tub. - Condensation may form on the
walls, particularly after the
appliance has cooled down
(sound insulation increases the
phenomenon)