Elation Professional PLATINUM BEAM 5R XM485-V1.0-NR - Manual (Page 18)

16
Personality:
Status setting
Address via DMX - This function allows the DMX address to remotely be
adjusted from a DMX console. This setting requires special settings for both the
controller and the fixture. RDMX is on by default. For operational instructions
please see Section 10/Page 35 of this manual “Remote DMX addressing.”
No DMX Status – This function dictates how the fixture will function if it looses
DMX signal during normal operation. The default function is set to hold, in which
the fixture will lock into the last DMX signal it received and remain in that
position until it is turned off or begins receiving a new DMX signal. If the fixture is
turned on without any DMX signal, the fixture will automatically go in to sound-
active mode. Available settings are: “Close” – Shutter flags will close. “Hold” –
Fixture will remain at it’s last settings. “Auto” – Fixture will go into stand-alone
mode, running the built-in program. “Music” – The fixture will go into sound-
active mode.
Pan Reverse - This function allows you to invert all pan movements. Use the Up
and Down buttons to turn this function On or Off. Press the Enter button to
accept the change or the Mode button to cancel and return to the main menu.
This function is “OFF” by default.
Tilt Reverse - This function allows you to invert all tilt movements. Use the Up
and Down buttons to turn this function On or Off. Press the Enter button to
accept the change or the Mode button to cancel and return to the main menu.
This function is “OFF” by default.
Pan Degree – This function changes the maximum Pan resolution from either
540˚ or 630˚. The default function is 540˚. 630˚ operation allows for greater
coverage, but slower pan movement.
Feedback – This function turns the feedback correction on or off. This function
is set to “ON” as default. This function allows for automatic pan and tilt correction
in the event either one disrupted during normal operation.
Movement Speed – This function changes the speed function of the Pan and
Tilt motors. Use this function intergrading Platinum Spot 5R into lighting rigs that
XM485-V1.0-NR