DE DIETRICH DHD1103X - Manual (Page 31)

31
4/ CLEANING THE HOOD EN
Careful maintenance helps guarantee proper operation and good results from an appliance
over time.
The hood must be unplugged from the electrical power source, both by unplugging
the appliance from the socket as well as de-activating the breaker, before removing the
metal filters.
After cleaning, you must replace the metal filters as outlined in the instructions.
MAINTENANCE HOW TO PROCEED?
ACCESSORY PRODUCTS TO
USE
External surfaces and
accessories
Do not use metallic scrub-
bers, abrasive products, or
hard brushes.
To clean the external sur-
faces of the hood and the
light housing screen use
only commercially available
household detergents dilut-
ed in water. Then rinse with
clean water and dry with a
soft cloth.
Filter cartridge
After 30 hours’ operation,
the button pad will sig-
nal that the grease filter is
saturated by flashing the 4
speed LEDs.
Press the timer button to
reset .
The grease filters can be
washed by hand or in the
dishwasher. These filters
need to be cleaned on a reg-
ular basis because otherwise
they may present a fire risk.
Refit the grease filters and
front panel, making sure that
the panel is properly fitted at
the sides so that it does not
cause the downdraft to stop
operating.
Active carbon filter
In the recirculation mode,
you must substitute the
active carbon filter peri-
odically.
To remove the fibre pan-
el you must first remove
the anti-grease grill and
pull the plastic knob on
the panel itself, remov-
ing it from its housing. To
replace the active carbon
filter, do the reverse. Re-
place the used carbon filter
on an average of every six
months.