beautypg.com

On switching on, On first use •while in use – DE DIETRICH DTi1041X User Manual

Page 12

background image

12

EN

4 / SPECIAL MESSAGES, DIFFICULTIES

The hob does not operate and
the indicator lights on the con-
trol panel do not light up.

The hob is not working and
another message is displayed.

The hob does not function, the
information is

displayed.

The machine is not connected to
the power source. The power
source or connection is defective.

The electronic board is func-
tioning poorly.

The hob is locked

Inspect the electrical cir-
cuit breaker and fuses.

Call the After-Sales
Service Department.

See chapter on using the
child safety system

•On switching on

YOU OBSERVE THAT:

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

A special lamp appears.

Your installation blows a fuse.

Only one side works.

The hob produces an odour dur-
ing the first cooking sessions.

Working normally.

The electrical connection of
your hob is incorrect.

New appliance.

Nothing, the light disappears
after 30 seconds.

Check that it is set up
properly.
See the “Electrical
Connection” section.

Nothing. The smell will dis-
appear after several uses.

•On first use

•While in use

YOU OBSERVE THAT:

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

The hob has stopped operating and is

beeping approximately every 10 sec-

onds and a

or F7 is displayed.

There was an overflow or an

object is in contact with the

control panel.

Clean the hob or remove the

object, then begin cooking

again.

A series of small

or F7 is dis-

played.

The electronic boards heated

up.

See “Inserting” section.

After turning on a heating zone, the

indicator lights on the control panel

continue to flash.

The cookware used is not suit-

able for induction or is less

than 12 cm in diameter (10 cm

on a 16 cm area).

See section on cookware for

induction.

The saucepans make noise during

cooking.

Your hob makes a clicking sound dur-

ing cooking.

This is normal with some

types of cookware. This is

caused by the transfer of

energy from the hob to the

cookware.

Nothing. There is no risk, nei-

ther to your hob nor to your

cookware.

The fan continues to function a few min-

utes after your hob is turned off.

Cooling of the electronic com-

ponents.

Working normally.

Nothing.

After turning on a heating zone, the

indicator lights on the control panel

remain steady but the cookware is not

heated.

The cookware used is not

suitable for use with induc-

tion.

See section on cookware for

induction.