DE DIETRICH DTV1120X - Manual (Page 12)

EN
27
4 / SPECIAL MESSAGES, DIFFICULTIES
In case of breakage, cracks or even light fissures in the vitroceramic glass, take out
the fuses or turn off the circuit breaker for your hob to avoid the risk of electrical
shock.
Contact the After-Sales Service Department.
The hob does not operate and
the indicator lights on the con-
trol panel do not light up.
The hob does not function, the
information is
displayed.
The machine is not connected to
the power source. The power
source or connection is defective.
The hob is locked Inspect the electrical cir-
cuit breaker and fuses.
See chapter on using the
child safety system
The hob has stopped operating
and is beeping approximately
every 10 seconds and a
or
F7 is displayed.
A series of small
or F7 is
displayed.
There was an overflow or an
object is in contact with the
control panel.
The electronic circuits have
overheated.
Clean the hob or remove
the object, then begin
cooking again.
See “Inserting” section.
•While in use
•On switching on
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO?
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO?
POSSIBLE CAUSES: WHAT SHOULD YOU DO?
A special lamp appears.
Your installation blows a fuse.
Only one side works.
Working normally.
The electrical connection of
your hob is incorrect.
Nothing, the light disappears
after 30 seconds.
Check that it is set up
properly.
See the “Electrical
Connection” section.
•On first use