SAF-HOLLAND XL-FW484 FW33 and XA-331 LowLube Series Fifth Wheels - Manual (Page 5)

XL-FW484 Rev E SAF-HOLLAND, Inc. 5
INSTALLATION INSTRUCTIONS
continued
Stationary Fifth Wheel Installation
continued
Bracket with Mounting Base
(See Figures 2A, 2B, and 2C):
1. Holland brackets with mounting
base are intended for installation
on either corrugated or flat
mounting plates.
2. In addition to the information
given in “Installation: General
Recommendations,” on page 3,
follow the recommendations in
FIGURES 2A, 2B, and 2C.
3. See “Installation: General
Recommendations” on page 3
for angle thickness and material.
The mounting angle should be 1˝
longer than the mounting plate,
and be 36˝ minimum length.
Use 3˝ minimum horizontal and
3-1/2˝ minimum vertical leg size.
Longer horizontal legs may be
required with narrow frame widths.
Attach the outboard angle to
tractor frame with hardware
listed in Figure 1A. Attach
mounting plate to angle
with same number of bolts
(in addition to attachment to
fifth wheel support bracket).
FIFTH WHEEL
SUPPORT BRACKET
TRACTOR FRAME
SPACER
INBOARD ANGLE
FLAT MOUNTING
PLATE (See Table 1 for
minimum thickness)
Attach the outboard angle to
tractor frame with hardware
listed in Figure 1A. Attach
mounting plate to angle
with same number of bolts
(in addition to attachment to
fifth wheel support bracket).
TRACTOR FRAME
CORRUGATED
MOUNTING PLATE
(See Table 1 for
minimum thickness)
FIFTH WHEEL
SUPPORT BRACKET
CENTER
BOLT
Attach bracket and mounting plate as shown.
Use center bolt of sufficient length to bolt through
bracket, mounting plate and mounting angle.
FIGURE 2C
FIGURE 2A
FIGURE 2B