SAF-HOLLAND XL-TG10156UD TLV Series Liftgate - Manual (Page 12)

12 XL-TG10156UD-en-US Rev A · 2013-04-18 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Liftgate Operation Instructions
Figure 15
Figure 16
PLACE LOAD
ON CENTER
OF PLATFORM
FRONT OF
PLATFORM
DECK HEIGHT
8. Platform Loading
Failure to keep load within platform edge
could create a crush hazard which, if not
avoided, may result in damage to the load.
Failure to keep loads stable and within
design capacity could result in falling objects
or component failure which, if not avoided,
could result in death or serious injury.
When riding the platform, failure to keep
feet within front edge of platform could
create a crush hazard which, if not avoided,
could result in death or serious injury.
8.1 Loading from the Ground
1. Using the control station, open the platform from the
stowed position and lower it to the ground (Refer to
Sections 6 and 7).
IMPORTANT: Never operate a fork lift truck on or over
the platform.
Failure to remove fork lift trucks from
the liftgate platform area could cause
component failure which, if not avoided,
could result in death or serious injury.
2. Load the platform by placing the load center as close to the
center of the platform as possible and placing the heaviest
part of the load to the front of the platform (Figure 15).
3. Using the control station toggle switch at the rear of the
vehicle, raise the platform to deck height and unload
(Figure 16). If required, repeat procedures to continue
with additional loads.
4. When the liftgate has been unloaded, lower and stow the
platform (Refer to Sections 6 and 9).
8.2 Loading from the Vehicle
1. Using the control station, open and raise the platform to
deck height (Refer to Sections 6 and 7).
2. Load the platform by placing the load center as close to the
center of the platform as possible and placing the heaviest
part of the load to the front of the platform (Figure 17).
IMPORTANT: Never operate a fork lift truck on or over
the platform.
Failure to remove fork lift trucks from
the liftgate platform area could cause
component failure which, if not avoided,
could result in death or serious injury.
3. Using the control station toggle switch on the rear of the
vehicle, lower the platform to the ground.
4. When the liftgate has been unloaded, stow the platform
(Refer to Section 9).
Figure 17
PLACE LOAD
ON CENTER
OF PLATFORM
FRONT OF PLATFORM