Purdy AND-TFT-5VX-4HB - Manual (Page 5)

AND-TFT-5VX-4HB
Displays
Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
05/13/03 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 5
CN 2
Note 1: Gate off voltage, V
EE
=10V.
Note 2 : Gate on voltage, V
GG
=19V.
Note 3 : Select up or down shift ( see Table 1 )
Note 4 : Gate driver shift clock
Note 5 : When OE is connected to high “1”, the driver outposts
are disabled (Gate output=V
EE
). Under this condition,
the operation of registers will not be affected.
Note 6 : Select left or right shift (
see Table 2 )
Note 7 : Latch the polarity of outputs and switch the new data
to outputs. At the rising edge (LD), latch the “POL”
signal to control the polarity of the outputs.
Note 8 : Control whether the Data RO~G5 are inverted or not.
(PVI suggests connecting to GND) When “REV=1”
these data will be inverted. EX: “00”
to “3F”, “07” to
“38”, “15” to “2A”
Note 9 : Polarity selector for dot-inversion control. Available
at the rising edge of LD. When POL=1: Even outputs
range from V1~V7, and Odd outputs range from
V8~V14, and Odd outputs range from V1~V7.
Pin #. Symbol I/O Function Remark
1 VSS2 | Ground
2 V1 I Gamma Voltage 1
3 V2 I Gamma Voltage 2
4 V3 I Gamma Voltage 3
5 V4 I Gamma Voltage 4
6 V5 I Gamma Voltage 5
7 V6 I Gamma Voltage 6
8 V7 I Gamma Voltage 7
9 VSS2 I Ground
10 V8 I Gamma Voltage 8
11 V9 I Gamma Voltage 9
12 V10 I Gamma Voltage 10
13 V11 I Gamma Voltage 11
14 V12 I Gamma Voltage 12
15 V13 I Gamma Voltage 13
16 V14 I Gamma Voltage 14
17 VSS2 I Ground
18 VDD2 I Voltage for analog circuit
19 VCOM I Common Voltage
20 XON I NC
21 OE I Output Enable Note 5
22 U/D I Right / Left Selection Note 3
23 CKV I Vertical Shift Cllock Note 4
24 STVU I Vertical Shift Pulse Signal Input or Output Note 3
25 STVD I Vertical Shift Pulse Signal Input or Output Note 3
26 VGG I Gate On Voltage Note 2
27 GND I Ground
28 VCC I Voltage for logic circuit
29 GND I Ground
30 VEE I Gate Off Voltage Note 1
Table 1
U / D STVU STVD Shift
1 Hi-Z Input Down to Up
0 Input Hi-Z Up to Down
Table 2
R / L D | O2 D|O2 Shift
1 Input Hi-Z Left to Right
0 Hi-Z Input Right to Left