Emprex HD-3701P - Manual (Page 46)

45
1. On the Channel menu, select the third
option, (Manual Scan), and then use the
or button to select (Manual Scan).
2. Press “OK” to highlight the input col-
umn. Then press numerical buttons to
input the channel. The channel frequen-
cy will be automatically shown on right
side of the input column.
3. Press “OK” when the messages “Add
channel” and “press Enter to add chan-
nel” are shown.
4. If the ATSC signal is found and locked,
the (status) will show the message (Get
No.XX 8VSB channel success), press
“EXIT” or “DTV MENU” to leave the
menu page, watch the program, or scan
other channels.
5. If the signal is not locked, the status will
show “Got No Channel”. You can scan
the signal again or refer to the signal
level bar “Signal” for aligning the direc-
tion of the antenna to get the signal.
6. When the signal is locked and the prod-
uct is on the channel, you can enter this
page to check the signal level.
Note: Contact the antenna installer it you
are haveing trouble locking the signal.
7. Press “EXIT” to go back to the main
menu or press “DTV MENU” to leave.
Channel Channel Caption Caption Setup Setup Lock Lock
Edit
Auto Scan
Manual Scan
Channel Channel
Caption Caption Setup Setup Lock Lock
Manual Scan Manual Scan
OFF AIR
Channel No : 34 Freq : 593000
Status : Press [Enter] to Add channel.
Signal : 72 %
Add channel
Memorizing Channel Manually
Channel Channel Caption Caption Setup Setup Lock Lock
Manual Scan Manual Scan
OFF AIR
Channel No :
Status : Add No. 34 8VSB channel successfully.
Signal : 0 %
0