Sandia 6-Quart Hipster Hip Vacuum - Manual (Page 8)

(8) Hipster 6-Quart Hip Vacuum Hipster 6-Quart Hip Vacuum (9)
4.0 Operation and Assembly Instructions
PREPARATION AND OPERATION. DRY ONLY!
This vacuum is equipped with an air-thru motor and is designed for dry pickup only.
Unpack the carton and remove the vacuum and attachments (if purchased with tools).
Getting Started:
1. Make sure your on/off switch is in the OFF position.
2. Remove lid and check to make sure you have both a cloth filter bag and paper filter
bag in place. Secure lid back onto the vacuum body, tightening securely. Both bags
must be used at all times. Any damage resulting from the lack of using both bags will
not be covered under warranty.
3. Do not tie or loop the pigtail cord with the extension cord.
4. Loosen the shoulder and waist belt straps and slide vacuum on.
5. Connect and tighten waist belt ensuring that majority of the weight is on your hips,
not your shoulders.
6. Adjust the shoulder straps for comfort.
7. Connect the sternum straps for added support and ideal fit.
8. Plug your vacuum into a properly installed outlet.
9. Turn unit on and proceed with vacuuming.
10. Always store vacuum, safety power cord and tools in a cool dry place indoors.
NOTE: The weight of the vacuum should be distributed on your hips. Adjust any strap as
needed for your custom fit.
To Change Paper Filter Bag:
1. Unclip the lid from body.
2. Remove full paper bag from the tank and dispose of
properly.
3. Take new paper filter bag and set inside cloth filter bag,
expanding it to the sides of the cloth filter bag.
4. Reinstall the lid, clamping the lid latches down tightly.
Cloth Filter Maintenance:
The cloth filter should be inspected and cleaned each time you empty the tank. DO NOT
wash the cloth filter. It could cause shrinkage of the cloth and damage to the gasket.
Simply shake off any dust or loose particles and brush the exposed surface with a soft
bristle brush.
CAUTION: Always exercise caution when handling the vacuum. Dropping the vacuum
could cause permanent damage to the internal components.
4.0 Operation and Assembly Instructions Continued
Maintaining the HEPA Cloth Filter:
When the white disk inside your dome filter is discolored, replace it with a new HEPA
filter with bag support. Replacement time frame of the HEPA filter depends on the
frequency and application of use. For best results, replace every six (6) months.
IMPORTANT: Following the above instructions is critical in prolonging the life of your
vacuum. All filters must be used at all times. Failure to do so will VOID your warranty.
Assembling Attachments:
The vacuum comes assembled, but you will need to install the hose to the wand and the
wand to the attachment.
Wand Assembly (for 2-Piece Wand Only):
• Align the button lock of the upper wand section with the opening
for the button lock in the lower wand section.
• Push the sections together until the button lock slides into place
and the lock is secured.
To Connect Wand to Hose:
• Insert the tapered end of the wand into the swivel cuff at the end
of the hose.
To Connect Wand to Attachments:
• Turn wand nut counterclockwise approximately four (4)
complete turns.
• Insert the tool into the wand and coupling.
• While holding the tool in place, turn nut clockwise until wand
nut is fully locked.