Sandia 6-Quart Hipster Hip Vacuum - Manual (Page 7)

(10) Hipster 6-Quart Hip Vacuum Hipster 6-Quart Hip Vacuum (7)
2.0 Grounding Instructions Continued
This electric equipment is for use on a normal 120 volt circuit. It has a grounded plug that
looks like the plug illustrated in (Fig A). A temporary adapter, such as illustrated in (Fig B
and C), may be used to connect this plug into a two-pole receptacle, as shown in (Fig B),
if a properly grounded outlet is not available.
The temporary adapter should be used only until a properly grounded outlet (Fig A) can
be installed by a qualified electrician. The green color rigid ear lug or the like extending
from the adapter must be connected to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
3.0 Care of your Hip Vaccuum
Treat your vacuum as you would any other high grade, precision made product.
Dropping, unreasonable bumping across thresholds and other misuses may result in a
damaged unit which will not be covered under warranty.
When not in use, the power cord should be wrapped around the molded-in cord wrap and
stored in a dry area. After each use, wipe the vacuum body, accessories and power cord
with a slightly damp cloth.
WARNING: DO NOT use vacuum without the proper cloth filtration bag, paper
filter bag and other filters in place. Failure to do so, will VOID your warranty.
If using this vacuum in a paint, sawdust or drywall environment, you must dispose of
the paper filter bag and the shakeout cloth filter bag after each use. Failure to do so will
cause severe damage to your vacuum and VOID your warranty. Dispose of the paper
filter bag in a fireproof container. The combination of urethane and wood, may result in a
combustion.
5.0 Troubleshooting Guide
CAUTION: Always disconnect power cord before servicing vacuum.
WARNING: Repairs should only be performed by an authorized service center.
Failure to do so will VOID warranty.
PROBLEM: Loss of vacuum
CAUSE SOLUTION
Lid is damaged Inspect and replace if needed
Faulty vacuum motor Call manufacturer or authorized service center
Full paper bag filter Replace paper filter bag
Clogged hose or wand Remove obstruction
Loose or broken fan Call manufacturer or authorized service center
PROBLEM: Motor is not running
CAUSE SOLUTION
Faulty on/off switch Call manufacturer or authorized service center
Power cord defective Call manufacturer or authorized service center
Loose connection or wiring Call manufacturer or authorized service center
Motor defective Call manufacturer or authorized service center
Blown fuse or tripped circuit breaker Replace fuse or reset circuit breaker
PROBLEM: Dust blowing from vacuum when running
CAUSE SOLUTION
Full paper bag Replace filter bag
Paper filter bag not installed properly Reinstall or replace paper filter bag properly
Cloth filter bag is dirty
Clean cloth filter bag by shaking and dusting
Cloth or paper filter bag is torn Replace - failure to use a
All filters must be used at all times. Failure to do so will VOID your warranty.