Sandia Gen-Air Air Mover - Manual (Page 5)

(8) 3-Speed Air Mover 3-Speed Air Mover (5)
2.0 Safety Instructions
READ THIS MANUAL BEFORE USING AIR MOVER. KNOW THE PROPER
OPERATION, CORRECT APPLICATIONS AND THE LIMITATIONS OF THIS
EQUIPMENT BEFORE USE.
Reduce the Risk of Fire, Electric Shock or
Injury:
• This air mover must be grounded. See section 3.0 for more
details.
• This air mover is designed for commercial use. It is
constructed for indoor use and its not intended for any
other use.
• DO NOT use in flammable or explosive areas. Never
operate this air mover near flammable or explosive dusts,
liquids or vapors.
• DO NOT use with damaged cord or plug.
• DO NOT use outdoors. Do not expose to rain. DO NOT
use in standing water.
• DO NOT use air mover if it not operating properly. Report
problems to a supervisor.
• DO NOT use with an extension cord.
• Wipe the chassis of the air mover to clean. Use vacuum to
remove dusts from fan blades. DO NOT wash with flowing
water.
• DO NOT use this air mover unless trained.
• DO NOT run any machines over the cord.
• DO NOT pull Air Mover by cord or plug.
• DO NOT pull cord around sharp edges or corners.
• DO NOT unplug by pulling on the cord.
• DO NOT stretch cord.
• DO NOT handle plug with wet hands.
• Keep cords away from hot surfaces.
• DO NOT allow air mover intake to collect burning or
smoking debris, such as cigarettes, matches or hot ashes.
DO NOT move air with flammable or explosive chemicals.
• Keep the air intake free of debris. DO NOT operate with
the intake covered or blocked.
Figure 1
Figure 2
Returned Material Authorization (RMA) Procedure
Original purchaser must contact the manufacturer to follow correct RMA/warranty
procedures. Must include a copy of RMA Sheet enclosed in the box with returned item.
No returns shall be authorized unless the proper RMA procedures are followed. It is the
responsibility of the distributor to repair the customer’s equipment as soon as possible. If
the distributor does not have the facilities to repair the equipment, it may be shipped or
taken to an authorized service center for repair.
Customer must contact the manufacturer prior to working on or changing out any
parts, etc. Manufacturer must issue an RMA Sheet containing approved labor time and
replacement parts. Do not send parts or equipment back to manufacturer without an RMA
# and approval. No labor will be paid for, nor part costs paid for or reimbursed that have
not been previously approved by manufacture. All warranty work must be approved and
authorized to qualify and appropriate warranty procedures must be followed.