Sandia Gen-Air Air Mover - Manual (Page 4)

(4) 3-Speed Air Mover 3-Speed Air Mover (9)
New Equipment Warranty
Lifetime on body, 1-year on all electrical components.
Warranty Policy
All equipment is inspected and tested before shipping from the manufacturer. All
parts are warranted to be new and free from defects in workmanship and material,
under normal use to the original retail purchaser. This warranty limits manufacturer’s
liability for defects in workmanship or materials to replacement of defective parts only.
Manufacturer accepts no liability for incidental or consequential damages arisen from
the use of any equipment, defective or not. This warranty is in lieu of all expressed or
implied warranties and is extended only to the original retail purchaser. Manufacturer
sales and service representatives are not authorized to waive or alter the terms of this
warranty, or to increase the obligations of the manufacturer under the warranty. Parts
replaced or repaired under this warrant are warranted for the remainder of the original
warranty period.
Freight charges and travel charges to and from the service provider shall be covered for
ninety (90) days from the purchase date. After the ninety (90) day period, these freight
charges shall be paid by the equipment owner, subject to manufacturer discretion. Certain
circumstances may require additional consideration. No travel charges shall be covered
after ninety (90) days.
Manufacturer covers up to 1-year (365 days) of service labor at MANUFACTURER’S
calculated hourly labor rate/repair time when performed by a manufacturer’s authorized-
service provider. Ultimately, labor reimbursement costs are at the discretion of the
manufacturer. After 1-year, original retail purchaser is responsible for all labor costs with
no manufacturer reimbursement.
Manufacturer charges a 15% restocking fee for any items that are being returned to stock.
Items must be new, unused and free of damage. Only good for up to 1-year (365 days).
After 1-year, manufacturer does not accept the return of any item(s) for a reimbursed
price.
Authorized warranty replacement parts need to come directly from the manufacturer.
Any use of any other parts will void warranty. Sandia Products, Inc. does not reimburse
for parts used by the customer that were not supplied directly for the machine under
warranty.
Electrical Power
This air mover operates on a 15 amp nominal 115 V, 60 Hz, A.C. power circuit. The amp,
hertz and voltage ratings are listed on the motor spec label found on each air mover.
Using voltages above or below those indicated on the spec label will damage the motor.
Always check your local voltage requirements.
3.0 Grounding Instructions
This air mover must be grounded while in use
to protect the operator from electric shock.
This machine is built with a 3-wire cord and a
3-prong grounding-type plug (Figure 1) to fit a
properly grounded receptacle.
Before using this machine, make sure a properly
grounded, 3-hole electrical outlet is available.
If not available, as in some older facilities, use
an adapter for connecting a 3-prong plug to
a 2-prong receptacle (Figure 2) to ground the
outlet chassis.
IMPORTANT: This adaptor may not be used
in Canada.
IMPORTANT: Never cut off the grounding
prong for use in a 2-prong outlet. By doing
so, you have cut off your protection from
electrical shock.
Never assume that all 3-hole outlets are properly
grounded. Check before use.
Figure 1
Figure 2
Never assume that an adaptor connection (as shown in Figure 2) is properly grounded.
Check the outlet with a ground fault interrupter device which quickly indicates if a
ground is connected.
Correct a faulty grounding before proceeding.
Extension Cords are Not Recommended
The air mover is built with a 20-foot, 16/3-gauge safety power cord. Use of any extension
cords is NEVER RECOMMENDED.