Rosen Aviation 1700 Series : 17 inch SlimLine - Manual (Page 11)

Page 10 Rosen Aviation Displays
The monitor may be configured to several options through
setting of Dip switches located near the input connectors.
The Dip switch settings are detected when 28 volts is
applied and each time the power button is pressed to turn
on the monitor.
Auto-Detect
This mode will automatically switch to the RGB input
whenever an RGB signal is connected to the monitor by
detecting the presence of the H-Sync signal (pin 8 of the
21WA4 combo connector). If no RGB signal is detected it
will automatically switch to the Composite Video input,
whether a video signal is present or not. The Source button
located on the front panel membrane switch and optional
external switch controller will be locked out.
Constant Ground
This mode uses a SPST (single pole single throw) external
rocker switch connected between ground and RGB/Video
Select (pin 6 of the 21WA4 combo connector). When the
RGB/Video Select pin is connected to ground the monitor
will switch to the RGB input, whether an RGB signal is
present or not. When the RGB/Video Select pin is not
connected to ground the monitor will switch to the
Composite Video input, whether a video signal is present or
not. The Source button located on the front panel membrane
switch and optional external switch controller will be locked
out.
Momentary Ground
This mode uses a SPST external momentary switch
between ground and the RGB/Video Select (pin 6 of the
21WA4 combo connector). Each time the switch is pressed
the monitor will switch back and forth between the RGB and
Composite Video input, whether a signal is present or not.
The Source button located on the front panel membrane
switch and optional external switch controller can also be
used to switch back and forth between the RGB and
Composite Video inputs.
Dip Switch Option Selection (cont)
Dip Switch Option Selection (cont)