Rose Electronics CrystalView DVI Micro DL - Manual (Page 4)

Disclaimer
While every precaution has been taken in the preparation of this manual, the manufacturer
assumes no responsibility for errors or omissions. Neither does the manufacturer assume any
liability for damages resulting from the use of the information contained herein. The
manufacturer reserves the right to change the specifications, functions, or circuitry of the
product without notice.
The manufacturer cannot accept liability for damages due to misuse of the product or other
circumstances outside the manufacturer’s control. The manufacturer will not be responsible
for any loss, damage, or injury arising directly or indirectly from the use of this product.
Introduction
Thank you for choosing the Rose Electronics CrystalView DVI Micro-DL Extender. The
CrystalView DVI Micro-DL extends a dual-link DVI video source up to 1,000 feet (300 meters)
using a duplex SC-type multi-mode fiber cable. A DVI Video Monitor can be extended away
from the host PC using the CrystalView DVI Micro-DL extender. Video resolutions up to 3840 x
2400 /60Hz and 1080p full-HD are supported.
The extension system consists of two units, a transmitter and a receiver. The transmitter
connects directly to your PC’s DVI port, or the DVI port of any video output device.
No add-on cables or adapters are required. The receiver unit connects directly to the LCD
monitor or display screen. The instructions in this manual assume a general knowledge of
computer installation procedures, familiarity with cabling requirements, and some
understanding of DVI device operation.
Features
• Extends dual-link DVI video up to 1,000ft (300m)
• Uses a duplex SC-type multi-mode (50/125um) fiber cable
• Supports HD resolutions to 1080p, 1920 x 1200 (WUXGA) and 3840 x 2400 (WQUXGA)
• TMDS video signal and EDID are transmitted over optical fiber
• Supports HDCP (Rev1.1) pass-through
• Supports HDMI 1.3