Rose Electronics CrystalView DVI CATx - Manual (Page 12)

INSTALLATION
6
CRYSTALVIEW DVI CATx INSTALLATION AND OPERATIONS MANUAL
Installation
Please refer to the safety section first before proceeding with any installation
or configuration of the CrystalView DVI CATX.
When installing the CrystalView DVI CATX, locate the transmitter as close as
possible to the CPU or switch. Keep the cables as short as possible but still
give some freedom of movement. Using shorter cables keeps the video noise
to a minimum and reduces installation costs. You can mount the CrystalView
DVI CATx in a CPU rack with the optional rack mount kit. When mounting the
units in a rack provide adequate air circulation to assure that the maximum
operating temperature is not exceeded.
Wherever the transmitter and receiver units are located, they should be on a
secure surface and free from obstructions and objects that may cause
damage to the units.
Figure 1. Typical cabling configurations
(See Figure 1 for the connector locations for your model)
NOTE: Local access provides for a second KVM station connected to the
transmitter. Damage to the unit can occur if the DVI connectors are connected
incorrectly. Make sure the DVI connector to the computer is NOT connected
to a DVI monitor.
The serial and audio transmitter connects to the computers serial and audio
ports (Line in / Microphone).
LOCAL KVM REMOTE KVM
ACCESS ACCESS
TRANSMITTER RECEIVER