Permissible key presses, Ultralink 2 installation and operations manual 25 – Rose Electronics UltraLink 2 User Manual

Page 29

UltraLink 2 Installation and Operations Manual

Notes
•

The entries are not case sensitive.

•

It is not necessary to specify all keys to be released at the end because they are all
released automatically after the last code.

•

A number of KVM switches from alternative manufacturers use hot key sequences
that begin with a press/release of either the Scroll Lock or Ctrl keys. These often
require a delay between the initial key press and the channel number to allow the
switch to respond. A 500ms delay is usually sufficient.

Examples:

To end the command Press/release Ctrl + 5 + enter, enter the following: +-Ctrl+-

5+enter

To send the command Ctrl + Alt 4, enter following: +Ctrl+Alt+4.
To send the command Ctrl + Alt 12, enter the following: +Ctrl+ALT+–1+-2
To send the command Ctrl + 1 + enter, enter the following: +Ctrl+-1+enter
To send the command Ctrl + 15 + enter, enter the following: +Ctrl+-1+-5+enter
(the ‘+–1’ entry causes the 1 key to be pressed and released before the-2 key is
pressed).
To send the command Scroll lock 1 + Enter (with a 500ms delay), enter the
following: +–Scr*500+1+Ent

Permissible key presses