Rose Electronics MultiStation CATx - Manual (Page 10)

6 MULTISTATION CATx INSTALLATION AND OPERATIONS MANUAL
Left Ctrl + Left Shift + k (Save Command) usage
Issuing the save command should be performed after all video commands
have been issued and before any other command is performed. Saving the
video settings turns off the TDR function. To turn the TDR function back on
issue the cable length command (left Ctrl + Left Shift + e), then the save
command.
Keyboard Commands - Country Codes
The following country code table allows you to enter the country code for type of
keyboard and operating system used. This function is only required if your
operating system is country specific and requires that a keyboard map specific for
your operating system be entered. Sun Japanese keyboards and others that
require this should enter their country code.
To enter the country code, enter the following key sequence:
Lctrl, Lshift, l, x, Enter, (non-cap L, x)
or
Lctrl, Lshift, l, x, y, Enter,
where X and Y are keyboard numeric keys.
If the country code number is a single digit (0-9), enter one digit (or two digits,
ie.06), followed by enter. If the country code is a double digit (10-35), enter both
numbers, followed by enter. Each key is pressed and released, and no more than
2 seconds can elapse between any two keys of the sequence, or the command
will abort. The command only has to be entered once. MultiStation CATx saves
the value in flash. The entered value does not change if the unit is flashed with
new code.
Code Country Code Country
00 Not Supported 18 Netherlands/Dutch
01 Arabic 19 Norwegian
02 Belgian 20 Persian (Farsi)
03 Canadian-Bilingual 21 Poland
04 Canadian-French 22 Portuguese
05 Czech Republic 23 Russia
06 Danish 24 Slovakia
07 Finnish 25 Spanish
08 French 26 Swedish
09 German 27 Swiss/French
10 Greek 28 Swiss/German
11 Hebrew 29 Switzerland
12 Hungary 30 Taiwan
13 International (ISO) 31 Turkish-Q
14 Italian 32 UK
15 Japan (Katakana) 33 US
16 Korean 34 Yugoslavia
17 Latin American 35 Turkish-F
36-255 Reserved