beautypg.com

Warning – Exmark Lawn Tractor User Manual

Page 26

background image

- 21 -

DO NOT attempt to turn the unit while on the ramp, you may lose control and
drive off the side.

Avoid sudden acceleration when driving up a ramp and sudden deceleration when
backing down a ramp. Both maneuvers can cause the unit to tip backward.

4. MAINTENANCE & ADJUSTMENTS

WARNING

POTENTIAL HAZARD
♦ While maintenance or adjustments are being made,

someone could start the engine.

WHAT CAN HAPPEN
♦ Accidental starting of the engine could seriously injure

you or other bystanders.

HOW TO AVOID THE HAZARD
♦ Remove the key from the ignition switch and pull the

wire(s) off the spark plug(s) before you do any
maintenance. Also push the wire(s) aside so it does
not accidentally contact the spark plug(s).

WARNING

POTENTIAL HAZARD
♦ The engine can become very hot.
WHAT CAN HAPPEN
♦ Touching a hot engine can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before service or

making repairs around the engine area.

4.1 PERIODIC MAINTENANCE

4.1.1

Check engine oil level:

Service Interval: Daily

a) Stop engine and wait for all moving parts to stop. Make sure unit is on a

level surface.

b) Check with engine cold.

c) Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the

dipstick and push it all the way down into the tube. Remove the dipstick
and read the oil level.

d) If the oil level is low, wipe off the area around the oil fill cap, remove cap

and fill to the “FULL” mark on the dipstick. Use oil as specified in Engine
Owner’s Manual. DO NOT

overfill.

IMPORTANT: DO NOT operate the engine with the oil level below the
“LOW” (or “ADD”) mark on the dipstick, or over the “FULL” mark
.

4.1.2

Check battery charge:

Service Interval: Monthly

Allowing batteries to stand for an extended period of time without recharging
them will result in reduced performance and service life. To preserve optimum
battery performance and life, recharge batteries in storage when the open
circuit voltage drops to 12.4 volts.