Precision Flight Serial CAT III and and X-Plane 8.61 User Manual
Page 3
CAT III System and X-Plane 8.61 Setup Guide
Page 3
Figure 1.1
Calibration:
18. Start X-Plane
19. A warning box will come up stating “Frame rate check passed, PFC hardware found, Flight Training is
Approved”
20. Press the enter key.
21. Now move the mouse all the way to the top and from the menu bar, choose Settings. If you do not see
a menu bar, you will need to close the map by clicking on the X upper left hand corner. Once closed,
move your mouse to the top again choose Settings.
22. From the Settings, choose Joystick & Equipment, and then choose Center.
Power Quadrant Calibration:
23. Make sure that you have a 6-lever or twin-prop lever installed to the console. Once installed, push all
levers to full forward position.
24. Click on SET MAX on Throt1, Throt2, Throt3, Throt4, Throt5, and Throt6.
25. Pull the levers all the way to aft position or bottom
26. Click on SET MIN on Throt1, Throt2, Throt3, Throt4, Throt5, and Throt6.