Precision Flight Serial CAT II and X-Plane 9 - Manual (Page 12)

SERIAL CAT - 2 BASIC AVIATION TRAINING DEVICE INSTALLATION AND CONFIGURATION GUIDE
CAT II BATD System
Installation and Configuration Guide January 2012
Revision 1
P a g e | 1-12
1.2 Change the protocol switch of Serial Cirrus II
For proper operation of the Cirrus II with the X-Plane 9.xx, the output protocol of the console will need
to be changed. Changing the position of the protocol switch will change the output data protocol of the
console to that of X-Plane will understand.
Note: This is a picture of the PFC THROTTLE QUADRANT CONSOLE but the location of
the switch is the same, behind the throttle quadrant lever.
To remove throttle quadrant you must:
1. Pull all the levers down (towards you). This will release the pressure from the push rods
2. Loosen the thumb screw by turning it counter clockwise