Precision Flight Serial CAT III and Microsoft Flight Simulator 9 (2004) - Manual (Page 9)

Serial CAT III and FS2004 Setup Guide Page 9
ADDITIONAL OPTIONS
1. On the Consoles page, please check the box for Parking Brake is a switch.
2. Also on the same Consoles page, please increase the Trim Sensitivity from 16 to 55. This box is located
on the right hand side.
3. Check the box for the Separate left and right cowl flaps.
4. Click on the predefined set. This should have changed the Action with PROP etc
5. At this point, please click on OK.
6. Press the ALT key again and go to Flight and then Exit
7. Start Microsoft Flight Simulator again.
8. Start Flying!
Serial_CATIII_System_and_FS2004_Setup_Guide.pdf REV051410